Heating in the advantages and disadvantages of the
/>
Analysis of the advantages and disadvantages of
advantages and green environmental protection, no pollution.
low-temperature radiation electrothermal film heating system does not produce Evaporative air cooler smoke and dust, no noise and dust caused by indoor air convection, in line with the requirements of urban planning, suitable for modern social green environmental protection requirements.
two, the advantages of fast heating, no cement backfill.
electrothermal membrane heating occupancy level, fast temperature rise, three minutes electrothermal film can be up to 45 degrees, half an hour floor heat (two or three hours floor heat) electrothermal membrane heating is in composite wood floors not only need to backfill cement floor heating, virtually electrothermal membrane heating is current most thin electric heating.
three, the economic advantages of convenience, can be costallocation.
low-temperature radiation electrothermal film heating system Air cooler can according to the needs of users, ready to start or shut down, and adapt to the needs of a variety of users, household, measured in units or floors, by the user the freedom to control power consumption. Therefore, the operating cost is very economical.
four, has no occupation of indoor space, free maintenance, maintenance free.
system work, keep the surface of the electrothermal film in low temperature, the highest temperature does not exceed 60 degrees celsius. Therefore, there will be no burns, caused by the explosion and fire accidents, the whole system is used in parallel connection, stable operation, high feasibility.
due to low temperature radiant electrothermal film heating system using radiation heating, will make you feel like in the sun as warm and comfortable. No traditional heating system by drying and mugginess.
/>
/>
electrothermal membrane itself strength is poor, more fragile than heating cable, leading to it in the process of construction and use can easily be destroyed. The cable from the inside to the outside by the multi-layer material, to ensure that it has a certain tensile and bending strength, and from the size of the cable, the cable is much stronger than the electric heating film.
two, > electrical faults
本文由: http://www.justaircooler.com 整顿并宣布！